CUSTOMER REPORTED RESULTS USING FAST PIERCE STAMPING
"The system runs fantastically--it gives us the quality and clean parts we need, is inexpensive, requires practically no maintenance, and, with no hydraulics and inherent hydraulic problems, is perfect for our clean room."
Bill Lunsford, Administrator
______________________
"The edge quality on these parts is as good as you will ever find” ... We constantly check for size, location, and roundness, any kind of contamination or defect per our own quality plan Actually, we have never had a rejection.
Greg Froebel, Inspection Supervisor
________________
Material: Brass electrical connectors. These cuttings are after the tool had 6.3 Million die strokes without resharpening. The shear edge characteristic indicates essentially no tool wear! We see no need to sharpen the die.
George Gobel, Operations Manager
________________
Pierce Punch & Die sharpening: Part 1240 (Hard Stainless) has shown a dramatic reduction of 582.9% in piercing punch and die sharpening. 527,500 parts/sharp vs. 77,273 parts/sharp..This is an expected effect of 'Fast Piercing' and is also due to reduced material spring back on the return stroke
Rollover: The rollover decreased by 55 .5% consistently across all three apertures on part 1240.
Aperture Features: The diameter features for both parts improved with the 'Fast Piercing' equipment. (overall improvement 24.8%)
C. Day
_______________________
"We are utilizing your two presses 7 days per week - 24 hours per day. We do not have in-house tool room for die sharpening. Your press technology makes die sharpening unnecessary! To date we have accumulated 12.2 million hits on the first press and 4.6 million on the second press. We have not had to stop running for die sharpening. Needless to say, tool wear has been non existent."
George Paszkiewicz, Business Manager
_____________________________
"The edge quality on these parts is as good as you will ever find” ... We constantly check for size, location, and roundness, any kind of contamination or defect per our own quality plan Actually, we have never had a rejection.
Greg Froebel, Inspection Supervisor
_____________________________
“Cutting our .001” thick amorphous material was previously impossible…. Flatness and burr are problems
of the past.
Thomas Rooney, Engineering Manager
_____________________________
"Bullet Press Edge quality makes possible the quality our customers demand. We have reduced our scrap by over 98%"
Ed Silver, Production Manager
Learn
More
Watch a Video Introduction
Netronics Research 333 Litchfield Rd New Milford, Ct 06776